|
Part Number: 2250 BMW Fuel Injector Oil Seal Kit
|
- Used for removing and installing the injector seal
- BMW N54 I6 & N63 V8 engines, and MINI N14 & N18 L4 engines
- Packed in a Blow Mold Case
- Compare to factory tool #83300495756
- Application: BMW N13, N14, N18, N20, N26, N43, N53, N54, N55, N63, N73, S55, S63, B38 & B48
Application Chart: | Make | Model | Engine | | BMW | All | N54 3.0L | | BMW | All | N63 4.4L | | MINI | Cooper S | All | | MINI | John Cooper Work | All | | MINI | John Cooper Work Clubman | All | | MINI | John Cooper Works | All | | MINI | John Cooper Works Clubman | All | | MINI | John Cooper Works WC50 | All | | MINI | S | All | | MINI | S ALL4 | All | | MINI | S Clubman | All | Instructions: - Disconnect and remove the Ignition Coil
- Remove the high pressure fuel line from the injector
- TIP: Cap off the fuel rail
- Disconnect the wiring harness from the injector
- Remove the securing bracket from the injector
- Using CTA Injector Pulling Tool/Slide Hammer, remove the injector
- TIP: Record the new injector calibration number and cylinder for later calibration
- Remove the cap on the end of the injector before installation
- Install the retaining clip
- Reinstall the new injector, ignition coil and fuel line
- Continue on to the remaining injectors
|
| |
|
|
